DS6-P-BLK

Our most compact vertical entry cable seal

For cables from 2-6mm (0.08"-0.24"), an aesthetic dome-shaped profile provides a stronger, impact-resistant design and captive nuts in the base make for an easy assembly.

Product Information.

Watertight Installation
Tapered bung forms a watertight seal. all units are supplied with a closed-cell base seal - 100% waterproof. All models have been IP68 tested and approved.

Easy and Reliable Installation
Captive nuts make for easy assembly and also allow reliable repeat installations. Each unit supplied with both pre-drilled and blank inner seals to make your installation as easy as possible.

Multi-Functional Dome Shape
The aesthetic dome-shaped profile provides a stronger, impact-resistant design (no sharp edges to hit your foot on!) and outer dome provides additional water shield.

Frequently Asked Questions

What's the best way to drill a blank bang?

Before drilling holes, freeze the blank seal in a freezer, this makes it very easy to accurately and neatly drill the hole. For best fit around cables drill a hole Ø1-2mm larger than the cable diameter.  When drilling into a frozen blank seal this hole will look far too big but when the seal defrosts, it will be a good tight fit.

Can this cable seal be installed below the waterline?

No, these seals are designed to be installed above the waterline.

In The Wild
Scanstrut Ingress Protection Raitings Guide

Scanstrut Ingress Protection Raitings Guide